||SS 15III TH|
||1978 SpeedStar SS15III THH air rotary.
1991 Wellen Casing Hammer with hydraulic swing out. For 6, 8, 10 inch with a 12 inch adaptor.
Factory extended Mast to 47 ft. to accommodate casing hammer.
Considered a 5 line rig.
Table with air wrench and hydraulic breakout wrench.
LeRoi Air Compressor 256S2 500 CFM at 1250 RPM
Set up for a mud pump.
12 gpm water injection
Truck is a 1978 GMC Brigadier
NTC 290 Ciummins
Eaton Roadranger 13 speed transmission put in later.
Everything always lubed since new with Synthetic oil and grease including the chain case and the pto.
PTO has been recently overhauled.
Chain case overhauled a few years back.
2 leaks: one down rigger has a small amount of oil on it, and one mast lifting hydraulic cylinder has a very slight leak out onto the rod chrome. Truck has absolutely no leaks.
Truck can be started and shut down from the rear panel.
Down hole hammers at least 2 are in good condition.
7 7/8 bits, 9 7/8 bit
Baler 3 ½, 4, 5 inch
Gas driven Miller welder by bobcat.
One set of cutting torches.
1984 Western Star 1750 gallon flat bed water truck with 475 twin turbo Cummins and a 15 speed Fuller Roadranger. Has the Canadian spread for the rear axles. Very nice truck with a good engine, and of course lubricated with synthetic oil. Interior in top shape for the age.
700 ft of 4 ½ drill steel along with some carbide and some non-carbide bits. 6, 8 and 10 inch stabilizers. May be selling some of the drill pipe to a local driller. Found out he sold the small diameter drill pipe.
1-Centrix 10 inch bit with 40 ft. heavy wall casing and casing shoe for concentric overburden casing drilling.
1-Tubex 6 inch bit with heavy wall casing and casing shoe.
Asking: $100,000.00 OBO for the drill.
Water Well Drill||